User's Manual

Stinger S650

Radar detector

Compass Calibration Set-up

Press ‘DIM/MENU’ and ‘MUTE/CITY’ buttons simultaneously more than 2

seconds to go ‘Compass Calibration Mode’.

Perform the calibration on a level surface, following these steps:

1. When entering ‘Calibration mode’, it speaks “start your calibration”.

2. The Calibration will be continued until user presses any key. Please drive 2

circles and press any key when finished. It displays and toggles ‘Drive_2’ and

‘CIRCLE’ during drive. The size of the circles and the direction you drive does

not matter. The circles do not need to be perfect circles but must be

completed in the same direction. Each circle should take a minimum of 20

seconds but no more than 1 minute to complete.

3. In case ‘Compass Calibration’ is completed successfully, it display

‘COMPLETE’ with voice of ‘Calibration completed’ and exit automatically.

4. In case it is not completed successfully, it displays ‘CANCELLED’ and exit.

5. If any button is not pressed during one minute, the calibration is stopped

and displays ‘ERROR’ and a ‘CANCELLED’ message.

Menu Mode

Pressing ‘DIM/MENU’ button for 3 seconds to go to ‘Menu’ mode. You can set

each sub menu as follows.

Press ‘DIM/MENU’ button again to scroll each sub menu and press ‘MUTE/

CITY’ button to select sub menu. After selecting sub menu, press ‘DIM/

MENU’ button more than 3 seconds to save and exit. Otherwise it is

automatically exit after 5 seconds with selected sub menu.

SUB MENU SELECTION REMARK

Language Mode

[LANG:ENG] / [LANG:RUS] ENGLISH or RUSSIAN

VG-2 Mode [VG-2:ON] / [VG-2:OFF] VG-2 ON or OFF

Voice Mode [VOICEoN] / [VOICEoFF] VOICE ON or OFF

Tone Mode [TONE:HIG] / [TONE:LOW] High tone or Low tone

Compass Mode [CMPS:ON] / [CMPS:OFF] Compass ON or OFF