User's Manual

- 6 -
d.SPEED MONITOR MODE : Speed Monitor function alerts the driver when a
preselected speed is exceeded. The speed Monitor can be set to any speed
between 40~100MPH (in 5mph increments) or 60~160KPH (in 10kph
increments)
The RLS2 emits a beeping alert tone accompanied by the visual display blinking
“Slow Down” repeatedly.
The alerts will continue until the vehicle’s speed is reduced to below the Speed
Monitor setting. The factory default setting for Speed Monitor is “Off”
To access and turn on this function:
-Press and hold CITY/HWY button for 3sec.
-Press and release Up(∧) and Down (∧) button to select the desired maximum
speed for alerts.
5seconds after your speed is selected, your setting will be saved, the voice will
announce “Speed Monitor Set” accompanied by the visual display blinking the
selected speed twice and your display will return to the main screen.
6) MARK Button
The Mark” function allows you to receive both audio and visual alerts for
specific locations you’ve stored.
Press and release Mark button when you are at the location.
Display shows “ Alrt Loc” and voice announces “Marked to Alert”.
After marking the location, when you arrive within a radius of 1500feet of the
marked location, the voice will announce “approaching marked location”
accompanied by visual display “Alrt Loc”
When you are at a marked location, you will hear a single “Bing” tone.
To remove a previously marked location, press and release Mark button while in
that location.
To remove all currently stored locations, select “All Alertlocs Clr” from Menu.
LIMITED WARRANTY
The manufacturer warrants this product against all defects in materials and
workmanship for a period of one (1) year from the date of the original purchase,
subject to the following terms and conditions: The sole responsibility of the
manufacturer under this Warranty is limited to either repair or, at the option of
the manufacturer, replacement of the unit. There are no expressed or implied
warranties, including those of fitness for a particular purpose of merchantability,
which extend beyond the face hereof.
- 7 -
SPECIFICATIONS
Radar Frequencies :
10.475 - 10.575 GHz (X Band)
24.050 - 24.250 GHz (K Band)
33.400 - 36.000 GHz (Ka Superwideband)
Laser Wavelength : 905nm +/-50nm
Operating Temperature Range :
-10C to +70C (+14F to +158F)
Power Requirements:
Operational 12 to 15volts DC,250mA nominal(2amp fuse) Vehicle Battery
Saver, 30mA nominal
FCC INFORMATION (FCC ID : W75-RLS2)
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
In addition, any changes or modifications to this product, which are not
expressly approved by K40 Electronics in writing, could void the user's authority
to operate this product.