User's Manual

Quick Start

(using factory default settings)

Once your K40 RL100 has been mounted and had the power

connected, you may begin using immediately by following

these steps:

1. Switch on the RL100 – Turn the Power On/Volume

Control Wheel on the side of the unit.

2. Wait for Test Scan to complete – The radar detector

will announce(voice) and display(screen)

K40 SCAN then

go through a “wake up sequence” lasting approximately

5 seconds

a. You will hear and see all bands tested. Adjust the

volume during this test.

b. Upon completion of the sequence scan, the screen

will display

HIGHWAY .

3. Wait for GPS Connection – After searching for available

satellites, the unit will announce “GPS Connected” then

display GPS .

4. You’re ready to drive! – The RL100 will now display

your speed and direction of travel. For example, if you are

driving west at 57 mph the display will show _W 57_ .

Please read the entire Owner’s Manual to fully understand

all of the RL100’s operations and functions.