Setup guide

If your RAID controller is not yet connected and configured on your local network, see Connecting to the
RAID Controller for the First Time on page 38.
Connecting to the RAID Controller for the First Time
Before you can connect to the RAID controller on your local network for the first time, you must set or
change its IP address. Each of the two RAID controllers in an XR RAID enclosure has its own IP address; you
can configure LUNs by connecting to either of the two. The factory default IP address of RAID controller 0
(the bottom controller) is 10.1.1.5. For RAID controller 1 (the top controller) the factory default IP address
is 10.1.1.6.
Connect the second Ethernet port on your workstation to the Ethernet port of RAID controller 0 (you may
require a twisted pair cat5 cable).
Then set the second Ethernet interface on your workstation to 10.1.1.x.
Launch the Stone Storage Manager RAID management utility by pointing a Web browser at the IP address
of the RAID controller, from your workstation. For example: firefox http://10.1.1.5:9292.
Setting the IP Address of the Controller
Once you are in Stone Storage Manager, you can change its IP address to one that is consistent with your
local network.
To set the IP address of the controller:
1 In the Stone Storage Manager, click Settings.
2 Select the Preferences tab.
38 | Chapter 7 LUN Management Guidelines