Product specifications

6-4
Changing System BIOS and Creating a Windows 2000 Image
2. If you need to enable the MIDI port, continue to step 3. If you do
not need to enable the MIDI port, go to step 8.
3. Press the Down Arrow key to reach the Devices and I/O Ports
menu selection and press Enter.
The Devices and I/O Ports menu appears.
4. Press the Down Arrow key to reach the Audio Setup menu
selection and press Enter.
The Audio Setup menu appears.
5. Press the Down Arrow key to reach the MIDI port selection.
6. Enable the MIDI selection by pressing the Left Arrow or Right
Arrow keys until you see IRQ5. If you see a yellow asterisk next to
the IRQ selection, this means there is some type of hardware
conflict and the IRQ cannot be used.
n
To enable the MIDI function, you must do more than just change the system
BIOS setting that enables the MIDI devices. A change in the MultiMedia
Control Panel setting must occur. These changes are performed when you
create the Windows 2000 image from the Avid Setup and Product Recovery
CD-ROM.
7. Press the Esc key to return to the Main menu.
8. Press the Down Arrow key to reach the Start Options menu
selection and press Enter.
The Start Options menu appears.
9. You are automatically placed at the Startup Sequence selection.
Press Enter.
10. Press the arrow keys to select the following startup devices under
the Primary Startup Sequence section:
- First startup — Diskette (floppy) drive 0
-Second startup — CD-ROM
- Third startup — Hard disk 0