Product specifications

4-10

Installing Memory, the Avid Board Set, and the Fan Kit

Before You Start the Installation

If you did not install memory, before you start the installation of the

Avid boards, you must make sure of the following:

• The system was turned off in a proper manner.

• The power cord is removed from the rear of the system.

•You read the User Guide IntelliStation Z Pro Type 6866 Professional

Workstation for instructions that explain how to open the system

and install the PCI boards.

• You use a proper antistatic grounding wrist strap during the

installation.

• You know the revision levels of the software and hardware (see

the release notes for your particular system).

• You determine the display controller board you have for use

during the driver installation section of this guide.

• You determine the slot locations of each board for your specific

system (see “Avid Board Configurations” on page 4-5).

The following sections are placed in the order that you might want to remove

and install boards. In general, you should start putting boards in at slot 7 (if

you have disk controllers) and work your way up the slot numbers.