Product specifications

A-8
Managing Disks on a Windows 2000 System
4. From the Partition menu, choose Configuration, and then choose
Save from the submenu.
The Insert Disk dialog box appears.
5. Click OK.
The stripe set disk configuration is placed on the floppy disk so
you can transfer it to the Windows 2000 system.
6. Write down the following information about the drive that
contains the Windows NT operating system for later use:
- Disk number — for example, 0
- Drive letter — for example, C
- Partition size — for example, 2047 MB
7. Close the Disk Administrator window.
Moving the Stripe Set to the Windows 2000 System
If you need to move the disk drives from the Windows NT system to
the Windows 2000 system, consider the following:
• Always turn off the system first, and then the drives.
• Make sure you have installed the latest drivers for the disk
controller board on the Windows 2000 system before you move
the stripe set.
• Determine the drive numbering (SCSI IDs) of the disk drives on
the Windows NT system and maintain the same SCSI IDs on the
Windows 2000 system. You might need to change the SCSI IDs of
existing drives on the Windows 2000 system.
• Make sure there are no SCSI ID conflicts.
• Make sure the termination is set properly after you move the
stripe set.
• Have all disk drives properly connected and turned on prior to
turning on the Windows 2000 system.