User`s guide

AVoption & AVoption XL Guide14
7 Attach the ribbon cable from the ABVB board
to the connector on top of the Janus Advanced
JPEG card by aligning the cable end with the
connector, and gently pressing it onto the card
until it clicks into place.
8 Close the computer or expansion chassis.
Installing the Digidesign
SCSI 64 / ATTO EPCI-DC SCSI
Accelerator Card
To install the ATTO ExpressPCI Dual-Channel SCSI
Accelerator:
1 Unplug and open your Macintosh computer
or expansion chassis according to the instruc-
tions included with it.
2 Release any static electricity by touching the
power supply, or another grounded item.
3 Remove the ATTO card from the antistatic
bag, being careful to handle it only by the edges.
4 Line up the ATTO card with the installation
slot, and slide the card into place gently so the
PCI connector is aligned with the PCI slot.
5 Press down firmly on the card with even pres-
sure. The connector should click into place in
the PCI slot.
6 Fasten the card in place using the included
screw to attach the card bracket to the computer
mounting bracket.
ABVB card and Janus Advanced JPEG card installed
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
ABVB card
Janus card
Ribbon cable
Digidesign SCSI64 / ATTO EPCI-DC SCSI Accelerator