Specifications

3
ATTO Technology Inc. FastStream SC Installation and Operation Manual
1.1 FastStream SC 7500R/D Physical Attributes
The ATTO FastStream SC 7500 R/D is a Fibre Channel to SAS/SATA storage appliance which can be seamlessly
integrated into an existing storage environment.
The ATTO FastStream SC 7500R/D is available in a
desktop model and in an industry-standard 1U form
factor for easy integration into racks. It supports next-
generation media and is equipped to handle the
throughputs needed by advanced disk technologies.
For installation instructions, refer to
Install the
FastStream on page 7.
Dimensions
Width: 17.31 inches
Length: 9.9 inches
Height: 1.69 inches (1U)
Weight: approximately 8 pounds
Cooling and airflow
Operating Temperature: 5 °C-40 °C
Humidity: 10-90% non-condensing
CAUTIONCAUTION
Do not block the enclosure’s vents. The
FastStream does not allow data transfer if
overheating occurs. Ambient air should
not exceed 40 °C.
Power
Input voltage: 100-240 VAC, 2.5A, 47-63 Hz
Battery-backed event log: A rechargeable Lithium
ion battery cell holds the event log memory for up to 30
days. If the FastStream has been disconnected from
power, recharging begins automatically when power is
restored to the system. The battery is fully charged
after 36 hours of continuous power application.
WARNING
WARNING
Risk of explosion if battery is removed
and/or replaced by an incorrect type.
Dispose of used batteries in accordance
with your local environmental regulations.
Explosionsgefahr, wenn die Batterie falsch
entfernt und/oder ersetzt wird. Entsorgen
Sie benutzte Batterien in Übereinstimmung
mit Ihren lokalen
Umweltschutzbestimmungen.
Fibre Channel ports
The four independent 4-Gigabit Fibre Channel ports
connect the FastStream SC 7500 to Fibre Channel
hosts using optical SFP connectors and multimode
fiber optic cable.
Make sure all cables are anchored securely at both
ends with the proper connectors.
SAS/SATA ports
The two (x4) 3-Gb SAS/SATA
ports connect storage devices
into the Storage Area Network
(SAN) using mini SAS 4x cable
plug connectors.
Management ports
Management is provided using the 10/100/1000 base
T Ethernet port accessible from the RJ-45 connector
or the RS-232 serial port using an RJ-11 connector.
(See Exhibit 1.1-2).
Reset/restore factory default switch
To reset the FastStream, briefly insert a tool in the hole
in the back panel for less than three seconds. See
Exhibit 1.1-1.
To restore factory defaults, insert the tool in the hole in
the back panel for more than four seconds until the
green Ready LED blinks.
LED indicators
The LED indicators can be viewed from the connector
side and the front side of the FastStream. (See Exhibit
1.1-1 and Exhibit 1.1-3)
LEDs on the connector side are:
Ready/Fault LED
lights green to indicate ready,
lights yellow to show a faulted condition, and is off to
indicate not ready.
Ethernet port connector: a lighted green LED
shows a valid link; off indicates that no link is present,
and blinking indicates activity. A separate bicolor LED
indicates 10/100/1000 MbE speed: green on indicates
100 MbE; yellow on indicates 1000 MbE, and off
indicates 10 MbE
Fibre Channel port: a lighted green LED indicates
link; off means no link. A separate green LED indicates