Specifications
ix
ATTO Technology Inc. FastStream SC Installation and Operation Manual
FCTargets (FS 7700 only)
Lists all target devices available on the Fibre Channel port with
the index specified by
fp
. If no port index is specified, then all
target devices on all Fibre ports are displayed. A port-unique
index is assigned to each target which is used with the
fp
to
specify a Fibre Channel target for a subsequent
Route
CLI
command.
FCTargets <fp>
FCWWName
Reports the World Wide Port Name of the Fibre Channel
interface referenced. Each Fibre Channel port has an individual
and unique 8-byte Port Name.
get FCWWName [fp | all]]
FirmwareRestart
Resets and reinitializes the unit firmware. Use the
forced
option to override any CLI reservations held by other sessions.
FirmwareRestart <forced>
Help
Issued with no parameters displays a list of available CLI
commands. When a CLI command name is specified, a
command usage string and command description are
displayed.
Help <Command>
HSAdd
Assigns a Block Device to the Hot Spare pool.
HSAdd [BlockDevID]
HSDisplay
Displays a list of all of the devices in the Hot Spare pool.
HSDisplay
HSRemove
Removes a Block Device from the Hot Spare pool.
HSRemove [BlockDevID] [all]
IdentifyBridge
If you enable this command, the Fault LED on this unit blinks so
that hardware may be identified. Disabling this option cancels
the blinking..
Default: disabled
set IdentifyBridge [enabled | disabled]
get IdentifyBridge
Info
Displays version numbers and other product information for key
components within the unit.
Info
IPAddress
Controls the current IP address of the Ethernet port(s) on the
unit. If
IPDHCP
is enabled, the get command reports the
current IP address assigned by the network DHCP server,
followed by the (DHCP) identifier.
Default: 10.0.0.1
set IPAddress [mp1] [xxx.xxx.xxx.xxx]
SaveConfiguration Restart command required
get IPAddress [mp1]
IPDHCP
Regulates how the unit acquires its IP address. When disabled,
the unit uses the IP address specified by the
IPAddress
CLI
command; when enabled, the unit gets its IP address from a
DHCP server.
Default: enabled
set IPDHCP mp1 [enabled | disabled]
SaveConfiguration Restart command required
get IPDHCP
IPDNSServer
Controls the current DNS Server address. If
IPDHCP
is
enabled, the DNS Server address is automatically detected. If
IPDHCP is disabled, you must set the address manually using
this command.
set IPDNSServer mp1 [xxx.xxx.xxx.xxx]
get IPDNSServer
IPGateway
Controls the current default gateways used by any Ethernet
port(s) on the unit. If
IPDHCP
is enabled, the get command
reports the current IP gateway assigned by the network DHCP
server.
Default: 0.0.0.0
set IPGateway [mp1] [xxx.xxx.xxx.xxx]
SaveConfiguration Restart command required
get IPGateway [mp1]
IPSubnetMask
Controls the current subnet masks used by any Ethernet port(s)
on the unit. If
IPDHCP
is enabled, the get command reports the
current IP subnet mask assigned by the network DHCP server.
Default: 255.255.0.0
set IPSubnetMask [mp1] [xxx.xxx.xxx.xxx]
SaveConfiguration Restart command required
get IPSubnetMask [mp1]
IsReserved
Displays the reservation status of the current unit.
IsReserved