Instruction manual

ManualsBrandsATTO Technology ManualsHome building and DecorSC-5700

ATTO Technology Inc. FastStream SC 5700 Installation and Operation Manual

1.1 Physical attributes

The ATTO FastStream SC 5700 is a Fibre Channel to Fibre Channel storage appliance which can be seamlessly

integrated into an existing storage environment.

The ATTO FastStream SC 5700 is available in an

industry-standard 1U form factor for easy integration

into industry-standard racks. It supports next-

generation media and is equipped to handle the

throughputs needed by advanced disk technologies.

Dimensions

Width:

17 inches

Length:

8.94 inches

Height:

1.7 inches (1U)

Weight:

approximately 8 pounds

Cooling and airflow

Operating Temperature:

0°-40° C external

Humidity:

10-90% non-condensing

Airflow:

air enters through slots on the right of the

rear panel and exits through slots on the left of the rear

panel.

CAUTIONCAUTION

Do not block the enclosure’s vents. The

FastStream SC 5700 does not allow data

transfer if overheating occurs.

Power

Input voltage:

100-240VAC, 1.7-.7A, 50-60 Hz

Battery-backed event log:

A rechargeable Lithium

ion battery cell holds the event log memory for up to

30 days. If the FastStream SC 5700 has been

disconnected from power, recharging begins

automatically when power is restored to the system.

The battery is fully charged after 36 hours of

continuous power application.

WARNING

Risk of explosion if battery is removed

and/or replaced by an incorrect type.

Dispose of used batteries in accordance

with your local environmental regulations.

Explosionsgefahr, wenn die Batterie falsch

entfernt und/oder ersetzt wird. Entsorgen

Sie benutzte Batterien in Übereinstimmung

mit Ihren lokalen

Umweltschutzbestimmungen.

Fibre Channel ports

The four independent 4-Gigabit Fibre Channel ports

connect the FastStream SC 5700 to either a Fibre

Channel Fabric or Fibre Channel Arbitrated Loop

using optical SFP connectors and multimode fiber

optic cable. Make sure all cables are anchored securely

at both ends with the proper connectors. Use the

shortest possible cable length for best performance.

Ports 1 and 2 connect to the host computer; ports 3 and

4 connect to devices (see Exhibit 1.1-1).

Ethernet port

The 10/100 base T Ethernet port is accessible from the

RJ45 connector and supports local diagnostics.

Serial port

The RS-232 serial port provides support

for remote monitoring and management

using a DB9 connector. The baud rate is

programmable and preset at the factory

to 115200 bps.

Reset/restore factory default switch

To reset the FastStream, briefly insert a tool in the hole

in the back panel.

To restore factory defaults, insert the tool in the hole in

the back panel for more than four seconds until the

green Ready LED blinks.

Cable length Cable size

Up to 175 meters 62.5 micron

Up to 500 meters 50 micron

GND