Instruction manual

xx
Appendix
TailEventLog
Displays new events to the terminal. Type q and press
Enter to exit tail mode.
TailEventLog
Temperature
Displays the current internal operating temperature of
this unit in degrees Celsius.
get Temperature
Time
Controls or displays the current time as clocked by the
unit in 24 hour format. Time cannot be set while
SNTP is
enabled.
set Time [HH: MM: SS]
get Time
TimeZone
Controls or displays the time zone or an offset from GMT
for the unit.
Default: EST
set TimeZone [[EST | CST | MST | PST] | [+/-HH:MM]]
get TimeZone
UserName
Specifies the user name used for all sessions: NDMP,
Telnet, FTP and ExpressNAV. user name is case
insensitive, 1 to 32 characters, and cannot contain
spaces. It is best practice to change the user name and
password from the default values. Refer to
Change
current user name, password on page 15.
Default: root
set UserName [user name]
get UserName
VerboseMode
Controls the level of detail in CLI Help output and
command response output for the current CLI session.
Default: enabled
set VerboseMode [enabled | disabled]
get VerboseMode
VirtualDriveInfo
Displays characteristics and statistics for all the
available virtual drives or any available virtual drive
identified by its virtual drive ID.
VirtualDriveInfo
Voltage
Displays the voltage levels monitored by the FastStream.
Representations of the voltages are
VDDA: +3.31 V
VDDB: +2.49 V
VDDC: +1.5V
VDDD: +1.35V
ALL: all monitored voltages
get Voltage [VDDA |VDDB |VDDC VDDD | all]
WrapEventLog
When enabled, the FastStream logs up to 2,048 event
entries before wrapping (overwriting the first entries). If
disabled, the FastStream stops logging event entries
when the buffer is full.
Default: enabled
set WrapEventLog [enabled | disabled]
get WrapEventLog
zModem
Uses the zMODEM protocol to transfer a file to or from
the unit via the RS-232 port. The filename to retrieve is
required if the
send option is specified.
Zmodem [send [filename] | receive]