Instruction manual

xviii
Appendix
RGWaitTimeout
Specifies the maximum time in seconds that the system
waits to discover previously-configured RAID groups
attached to the drive. The timeout is used during system
boot time and when the
BlockDevScan command is
issued.
Default: 5
set RGWaitTimeout [1-3600]
get RGWaitTimeout
RGWritePattern
Writes a DWORD pattern of four hexadecimal bytes to
the entire specified existing RAID group.
CAUTIONCAUTION
If the RGWritePattern command is used,
the RAID group is set to offline and all data
is lost.
RGWritePattern [GroupName] [Pattern]
RMState
Sets the member state on the specified existing RAID
group member(s). RAID group may not be in the NEW
state. Optional parameter MemberIndex specifies the
RAID Member whose status is to be set. If no
MemberIndex is specified, the status of all members of the
specified RAID group is set.
Note
Members undergoing rebuild are not changed.
Rebuilds on these members must first be
stopped.
set RMState [GroupName] <MemberIndex> [Online |
Degraded | Unavailable | Faulted]
RMStatus
Displays the status of all RAID Members within the
specified RAID group or a specific RAID member (if
specified) within the specified RAID group. The command
fails if the specified RAID group does not exist or a
specified member index within the RAID group does not
exist.
RMStatus [GroupName] <MemberIndex>
Route
Assigns a LUN protocol address to a target. Use the
Delete identifier to remove the map. In verbose mode,
overwriting a map requires secondary confirmation of
the action.
FCMultiNode disabled: Route FC [fl] [ RAID
[GroupName] [Partidx] ] | Bridge | Delete ]
FCMultiNode enabled: Route FC [fp] [fl] [ RAID
[GroupName] [Partidx] ] | Bridge | Delete ]
RouteDisplay
Displays a list of Fibre Channel to address mappings on
the FastStream.
FCMultiNode disabled: RouteDisplay FC <fl>
FCMultiNode enabled: RouteDisplay FC <fp> <fl>
SaveConfiguration
Issued with the restart option, cycles unit power after
saving configuration changes. The
norestart option
saves changes without restarting.
Note
Certain modifications require a system restart.
SaveConfiguration <Restart | NoRestart>
SCSIDomainValidation
Runs Domain Validation tests on the SCSI system which
may detect problems with SCSI cables, termination or
damaged transceivers. Tape drives attached to the
FastStream should be loaded with media. The media is
not overwritten. Disable
VirtualDriveInfo before
running this test and reboot the FastStream after running
the test.
SCSIDomainValidation
SCSIInitID
Specifies the persistent SCSI Initiator ID used by the unit
on this SCSI bus. All maps coinciding with the user-
specified SCSIInitID are destroyed after this command is
issued.
set SCSIInitID [sb] [0-15]
get SCSIInitID [sb]
SCSIPortBusSpeed
Controls the transfer rate at which the unit attempts to
negotiate with its SCSI devices.
set SCSIPortBusSpeed [sb] [fast | ultra | ultra2 | ultra3] |
ultra160 | ultra320]
get SCSIPortBusSpeed [sb]