Instruction manual

xiii
ATTO Technology Inc. FastStream SC 5300 Installation and Operation Manual
FCDataRate
Specifies the rate the FastStream uses, 1 Gigabit/sec., 2
Gigabit/sec. 4 Gigabit/sec. or auto negotiate.
Default: auto
set FCDataRate [fp | all] [1Gb | 2Gb | 4Gb | auto]
Requires a SaveConfiguration command
get FCDataRate
FCHard
Used to enable or disable FC hard address assignment.
Under soft addressing, the FastStream loop address is
assigned during loop initialization.If you enable hard
addressing use
FCHardAddress (described below).
Default: disabled
set FCHard [enabled | disabled]
Requires a SaveConfiguration command
get FCHard
FCHardAddress
Sets/displays the value used as the FC-AL hard address.
This hexadecimal value represents the address the
FastStream tries to use if hard addressing is
enabled.Refer to
FCHard . When an address is not set,
the current value is displayed. The valid range of values
is 0 through 125.
Default fp1=3; fp2=4
set FCHard Address [fp | [address]]
Requires a SaveConfiguration command
get FCHardAddress [fp | all]
FCMultiNode
When enabled (multi node), each port reports a separate
unique Node Name and logical units may be mapped to
either port. When disabled (single node), each port
reports the same Node Name and each logical unit
mapping is applied to all ports. The command is the basis
for a special configuration in the ExpressNAV interface
Audio Setup Wizard. Refer to
Audio on page 8.
set FCMultiNode [enabled | disabled]
get FCMultiNode
FCPortErrors
FCPortErrors displays the number of Fibre Channel
errors that have occurred since the last reboot/power-on
or ResetFCPortErrors.
get FCPortErrors
FCPortFailover
Regulates the current operating mode of FC ports on the
unit. When disabled, all Fibre Channel ports are active.
When enabled, a designated Fibre Channel port is
marked as reserved and becomes active only in the event
of a port failure. In the case of such a failure, the failover
port takes on the identity of the failed port. If this option
is enabled, all device maps on the designated failover
port are deleted.
set FCPortFailover [enabled | disabled]
get FCPortFailover
FCPortList
Returns a list of available FC ports and their current
status. Valid status values are
Up, Down, Failed,
Reserved
and Disabled.
FCPortList
FCPortRecover
Controls the behavior of Fibre Channel ports while the
unit is operating in port failover mode. The unit tries to
restore the pre-failover state after a failover condition.
Refer to
FCPortFailover .
FCPortRecover
FCWWName
Reports the Word Wide Name (WWN) of the FC interface.
Each FC port has an individual and unique WWN. The
least significant 3 bytes of the WWN are used as the
Ethernet MAC address. The lower nibble of the highest
byte designates the port number.
get FCWWN [fp | all]
FirmwareRestart
Resets and reinitializes the unit firmware. Use the forced
option to override any CLI reservations held by other
sessions.
FirmwareRestart <forced>
Help
Displays a list of available commands. If command name
is specified, displays detailed command-specific
information.
Help <command name>
HSAdd
Assigns a Block Device to the Hot Spare pool.
HSAdd [BlockDevID]