Instruction manual

xii
Appendix
EmailPassword
Configures the password used to authenticate the login to
the SMTP E-mail server. The password must not be more
than 64 characters. A password is not required if the E-
mail server does not require authentication.
set EmailPassword [password]
EmailServerAddress
Configures the address of the server that the FastStream
should contact in order to send E-mails.
Default: 0.0.0.0
set EmailServerAddress [IP address]
get EmailServerAddress
EmailUsername
Configures the user name used to authenticate the login
to the SMTP E-mail server. The user name cannot exceed
128 characters. A user name is not required if the E-mail
server does not require authentication.
set EmailUsername [user name]
get EmailUsername
EthernetMDIX
Specifies the Ethernet twisted-pair connection type.
The
MDI setting connects the unit's Ethernet port to an
Ethernet hub or switch port with a standard Ethernet
patch cable (or to a PCI card with a cross-over cable).
The
MDIX setting connects the unit's Ethernet port to an
Ethernet PCI card with a standard Ethernet patch cable
(or to a hub or switch with a cross-over cable).
The
Auto setting attempts to automatically determine the
correct setting.
Default: MDI
set EthernetMDIX [mp1] [MDI | MDIX | auto]
get EthernetMDIX [mp1]
EthernetSpeed
Sets/displays the current speed of the Ethernet
connection.
Default: auto
set EthernetSpeed [mp1] [ 10 | 100 | Auto ]
Requires a SaveConfiguration command
get EthernetSpeed [mp1]
EventLog
When enabled, records various system errors to the event
log.
Default: enabled
set EventLog [enabled | disabled]
get EventLog
EventLogFilter
Filters data from specific unit subsystems and levels when
event logging is enabled. The specific entries supported
are platform-dependent. For set commands, the final
parameter indicates whether or not events from the
specified subsystem and level is displayed.
Subsystem Levels
ECC INFO
ENET WARN
GEN CRIT
HTTP FAIL
NVRAM ALL
iSCSI
PERF
SCSI
NDMP
FC
ALL
Default: all all all
set EventLogFilter [subsys | all] [event level | all] [all
|none]
get EventLogFilter [subsystem] [level]
Exit
Exits the current Ethernet telnet CLI session; it has no
effect if used during a serial or in-band CLI session.
Exit
FCConnMode
Controls/reports the connection mode the FastStream
uses when communication across a FC network, either to
a Fibre Channel arbitrated loop (FC-AL) when you select
loop mode, or point-to-point when you choose ptp . If you
choose
loop-ptp or ptp-loop , the FastStream tries to use
the first parameter first.
Default: loop
set FCConnMode [fp | all] [loop | ptp | loop-ptp | ptp-loop]
Requires a SaveConfiguration command
get FCConnMode [fp | all]