Instruction manual

x
Appendix
BlockDevIdentify
Causes the I/O LED of the drive to illuminate for one
minute if it is accessible through the FC port
.
CAUTIONCAUTION
The BlockDevIdentify command is
intended for diagnostic purposes only.
Executing this command may adversely
impact the performance and throughput
of the FastStream for the time that the
LED is illuminated.
ts port.
BlockDevIdentify <Groupname> [BlockDevID |
MemberIdx]
BlockDevIDStop
Turns off the IO LED of a previously identified disk drive.
BlockDevIDStop
BlockDevScan
Lists all currently connected physical drives along with
any potential RAID group association. Each block device
listed is assigned a unique index at the time of the scan to
identify drives for other CLI operations. The optional
flush parameter forces rediscovery of all block devices
and forces all existing RAID groups offline until member
block devices are discovered.
BlockDevScan <flush>
BootFibreDelay
Regulates the delay (in seconds) which the unit waits
after startup before enabling the Fibre Channel ports.
The value
0 constitutes no delay.
set BootFibreDelay [0 | 15 | 30 | 45 | 60 | 75]
get BootFibreDelay
BridgeModel
Reports model information about the FastStream.
get BridgeModel
BridgeName
Specifies the eight-character name assigned to the
FastStream used to identify individual FastStream units.
It is not the World Wide Name. The string is
alphanumeric, eight characters long,.
Default: ““
set BridgeName [value]
get BridgeName
ClearEventLog
Clears the contents of the event log. No new entries are
recorded until ClearEventLog has completed.
ClearEventLog
Date
Regulates the current date for this unit. The date range is
01/01/2000 to 12/31/2099.
set Date [MM] / [DD] / [YYYY]
get Date
DefaultInterleave
Assigns or retrieves the system-default interleave size for
new RAID groups, where the interleave size is expressed
as the number of 512-byte blocks. If an interleave size is
not explicitly specified when a RAID group is created,
then the
DefaultInterleave value is used instead.
CAUTIONCAUTION
Changing the default interleave size may
degrade performance.
Default: 128
set DefaultInterleave [16 | 32 | 64 | 128 | 256 ]
get DefaultInterleave
DeleteAllMaps
Removes all mapped devices from the map table. Upon
the subsequent POST, if no maps are present the default
maps are loaded.
DeleteAllMaps
DHCPFixedDelay
Selects/displays the delay, in seconds, between DHCP
client request intervals, from between 0 seconds to 255
seconds.
0 time is typical.
Default: 0 (no delay)
set DHCPFixedDelay [ 0 - 255 ]
get DHCPFixedDelay
DisplayEventLog (all other bridges/appliances)
Displays the event log.The event log may be filtered using
the
DisplayEventLogFilter command. The optional
parameter
n is the number of lines to be displayed as a
single page with no user interaction. After the
command has executed, use
+ , - or = to scroll
through the log
. Press q to exit the command.
DisplayEventLog <n>