Instruction manual

ix
ATTO Technology Inc. FastStream SC 5300 Installation and Operation Manual
CLI command explanations
Command Line Interface commands are listed
alphabetically with explanations of what they are
used for, their defaults and syntax.
CAUTIONCAUTION
Using CLI without contacting an ATTO
technician is not recommended because
changing parameters may cause loss of
data and/or disruption to performance and
reliability of the FastStream.
The ExpressNAV interface is the preferred
method to manage the FastStream SC
5300. Refer to
Interface options on page
27 for details
AutoMap
Automap automatically maps a subset of target
devices visible to the firmware. All previous maps are
deleted.
AutoMap <fp>
AutoResume
Enables/disables the automatic continue feature for
interrupted rebuild, erase and write pattern operations at
startup. If
AutoResume is enabled, all interrupted
rebuild, erase and write pattern operations are continued
at startup. Optional parameter GroupName specifies the
RAID group whose
Restart features to be set. If no
GroupName is specified, all existing RAID groups are
affected.
Default: all disabled
set AutoResume [Rebuild | Erase | WritePattern | all]
[enabled | disabled] <GroupName>
BlockDevClean
Removes any ATTO configuration data from the block
device with the specified BlockDevID. BlockDevID is the
index of a block device provided by the
BlockDevScan
CLI command.
CAUTIONCAUTION
All RAID group setup information is lost
therefore all data is lost. Back up your files
before performing this command.
BlockDevClean [BlockDevID]
SCSIPortSyncTransfer enabled set scsiportsynctransfer 2 disabled
SCSIPortTermination enabled set scsiporttermination 1 enabled
SCSIPortWideTransfer enabled set scsiportwidetransfer 2 disabled
SCSITargetLUNs 8 set scsitargetluns 1 64
SCSITargets scsitargets 1
SerialNumber get serialnumber
SerialPortBaudRate 115200 set serialportbaudrate 19200
SerialPortEcho enabled get serialportecho
SNTP enabled get sntp
SNTPServer 192.43.244.18 set sntpserver 129.6.15.28
TailEventLog taileventlog
Temperature get temperature
Time 00:00:00 set time 03:32:30
TimeZone EST set timezone pst
Username root set username Barbara
VerboseMode enabled set verbosemode disabled
VirtualDriveInfo virtualdriveinfo
Voltage get voltage
WrapEventLog enabled set wrapeventlog disabled
zModem zmodem receive
Command Default Example