Instruction manual

28
Use Telnet
Up to three Telnet sessions can be conducted
simultaneously. A serial port session can use the
CLI while Telnet sessions are open. Whichever
session issues the first “set” CLI command can
continue to issue set commands, while the other
sessions can only issue “get” commands or
display information. Once a connection is
established, refer to CLI provides an ASCII-
based interface on page v of the Appendix.
1 Connect to the FastStream SC 5300 from a
computer on the same Ethernet network.
2 Start a Telnet session.
Note
There is more than one way to connect to the
FastStream SC 5300 using a telnet
program.Your telnet program may operate
differently than in the following instructions.
3 At the telnet prompt, issue the open command
where x.x.x.x is the IP address of the
FastStream SC 5300.
telnet > open x.x.x.x
4 If you have to specify a port type, type in the
port type “telnet” and the terminal type “vt100”.
port type: telnet
terminal type: vt100
5 Type in the default values for the user name,
root, and the password, Password, if you did
not set new values in Change current user
name, password on page 15.