Instruction manual
19
ATTO Technology Inc. FastStream SC 5300 Installation and Operation Manual
3The Manage Menu page appears. Click on the
FastStream arrow.
4 Click the Set up Error Notification button
5 Click Next.
6 Click on the Enabled button for Notification
Configuration
7 Type in the sender address (E-mails show this
name in the From field)
8 Type in the SMTP Server IP Address
9 Type in the user name and password of your
SMTP E-mail account
10 Type in up to five E-mail addresses
11 Choose All, Critical or Warning for each E-
mail address.
12 When all information is typed in, click Commit.
13 Your settings are displayed. You may change
or disable E-mail notification at any time from
the Error Notification page.
Exhibit 3.0-1 The E-mail messages sent by the FastStream SC 5300 follow this format.
Subject: [The Type of Event that Occurred]
Message Body:
This is a status message from [FastStream name]. Identifying information as well
as the most recent entries from the event log appear below.
*************** Unit Information ***************
Serial Number : [Serial Number]
IP Addresses: [IP Address1]
[IP Address2]
*************** Event Log Entries ****************
[Listing of the ten latest event log entries]
Identify drive issues
New performance data is updated every 60
seconds which impacts performance slightly,
even if you minimize the browser window. Exit
the browser ExpressNAV interface completely
whenever you need maximum performance.
Preliminary steps
1 If you are not already in the ExpressNAV
interface, type the IP address of your appliance,
as found in Use the ExpressNAV interface
on
page 27, in a standard browser, click Enter
Here and type in your user name and
password.
2The Health and Status Monitor page
appears.Click the Diagnostics button on the
left hand menu.
3 Select the operation you wish to perform from
the next menu presented.
Verify storage
CAUTIONCAUTION
Data may be erased during this process.
Back up your data before selecting
Commit
.
You may verify the status of storage which does
not belong to a RAID group (unattached storage)
to identify drive issues after drives have been
initialized.