Instruction manual

18
Display page (refer to Configuration Display
page below).
• RAID Group Status
RAID Group names, RAID status, available
Hot Spares and number of faulted drives
• Environmental Status
Temperature and voltage
• Interface Status
Ethernet management port link status and
Fibre Channel port link, speed and
connection mode
• Drive status by port
Size and status of each drive on each port
Configuration Display page
Clicking on Details in the Health and Status
Monitor page gives you added information about
each parameter on the Configuration Display
page. You may view the details of any parameter
from this page.
• RAID groups
RAID group names, RAID status, available Hot
Spares, number of faulted drives, RAID Level,
Interleave and total capacity of each RAID
group.
• Drives
Drive configuration by port, including drive size
and status
• Interfaces
Ethernet management port link status and Fibre
Channel port link, speed, connection mode,
Node Name and Port Name.
Note
At any point, if you do not want to continue
before you click
Commit, click on the Cancel
button to return to the previous setup menu.
Phone home: E-mail messages provide error notification
E-mail notification allows the FastStream SC
5300 to send an E-mail message to you, a network
administrator or other users when certain events
occur with the FastStream. Serious error
messages are sent immediately, while messages
for less serious errors are sent every 15 minutes.
• Types of errors
• Device errors such as medium error,
aborted command and hard error
• Device transitions from online to offline
• Critical and warning temperature conditions
• Critical and warning voltage conditions
• Power recycle/power failure conditions
• Warning messages
• device down
• medium error
• abort command
• Warning levels
• All: warnings, critical events and
informational messages are sent
• Critical: critical event E-mails are sent
• Warning: warnings and critical event E-
mails are sent
• None: no E-mails are sent
You may send E-mails to up to five E-mail
addresses and designate which conditions prompt
each E-mail notification.
For example, a recipient with a critical severity
level only receives critical messages and not
warning or informational messages.
When an event occurs that warrants E-mail
notification, the FastStream SC 5300 sends the
message; it cannot respond to a rejection by a
server for an invalid address. Ensure all E-mail
addresses typed in are valid.
Each E-mail is time stamped when it leaves as
part of the SMTP header information as shown in
Exhibit 3.0-1.
1 If you are not already in the ExpressNAV
interface, type the IP address of your appliance,
as found in Use the ExpressNAV interface
on
page 27, in a standard browser, click Enter
Here and type in your user name and
password.
2The Health and Status Monitor page appears.
On the menu at the left hand side of the page,
choose Manage.