Instruction manual

17
ATTO Technology Inc. FastStream SC 5300 Installation and Operation Manual
3.0 Monitor storage, configurations
You may determine the performance of drives attached to the FastStream SC 5300 using various
displays and tests in ExpressNAV interface.
The following instructions assume you have
already set up at least one RAID group. Refer to
Configure RAID on page 7.
The ATTO FastStream SC 5300 collects various
metrics to measure performance for physical
drives attached to the FastStream during normal
system operation and drive initialization and
verification.
CAUTIONCAUTION
New performance data is updated every 60
seconds which impacts performance
slightly, even if you minimize the browser
window. Exit the ExpressNAV interface
completely whenever you need maximum
performance.
Health and Status Monitor page
The Health and Status Monitor page is the
first page you see when you open the
ExpressNAV interface after completing the
configuration of at least one RAID group. You
may return to it at any time by clicking on the
Monitor button on the left hand side of the
screen.
1 If you are not already in the ExpressNAV
interface, type the IP address of your appliance,
as found in Use the ExpressNAV interface
on
page 27, in a standard browser, click Enter
Here and type in your user name and
password.
2The Health and Status Monitor page appears.
If you click Details, added information about
each parameter appears on the Configuration