Instruction manual

15
ATTO Technology Inc. FastStream SC 5300 Installation and Operation Manual
2.4 Optional changes to system setup
Default values are appropriate for most configurations, but may be modified for your needs using ATTO
FastStream SC 5300 browser-based user interface.
It is best practice to change the default user name
and password to a user name and password
significant to you. Other configurations may also
be changed, however, use extreme caution when
changing default values.
Change current user name, password
It is best practice to change the user name and
password.
1 Open a Command Line Interface session either
using Telnet or the serial port as shown in
Interface options
on page 27.
2Type set username [user name]
3 Press Enter.
4Type set Password
5 Press Enter
6 Follow the instructions on the screen to confirm
your old and new password.
Note
The user name is case insensitive and
password is case sensitive.
The user name and password for all Telnet, FTP
and ATTO FastStream SC 5300 browser-based
user interface sessions is changed.
Change system configurations
You may change whether the system uses the
Simple Network Time Protocol or a manually set
time; the data rate, connection mode and hard
address value of each Fibre Channel port, and the
bus speed and Initiator ID of each SCSI port.
1 If you are not already in the ExpressNAV
interface, type the IP address of your appliance,
as found in Use the ExpressNAV interface
on
page 27, in a standard browser, click Enter
Here and type in your user name and
password.
2 Click on the Manage button.
3 Click on Next.
4 Click on the FastStream arrow.
5 Click on the System Configuration button
6 Click on Next.
7 When you have completed your changes, click
on Commit.
Advanced CLI page
Changes to other parameters may be made using
the
Advanced page.
CAUTIONCAUTION
Do not use this page unless you are
directed to by an ATTO technician.
Changing parameters may cause loss of
data and/or disruption to performance and
reliability of the FastStream.
Note
The ExpressNAV interface is the preferred
method to manage the FastStream SC 5300.
1 If you are not already in the ExpressNAV
interface, type the IP address of your appliance,
as found in Use the ExpressNAV interface
on
page 27, in a standard browser, click Enter
Here and type in your user name and
password.