Instruction manual

9
ATTO Technology Inc. FastStream SC 5300 Installation and Operation Manual
2 Click on Next.
Note
Depending on your choice and your current
system, the appliance may need to restart.
3 If all your drives do not appear in the Find
Drives box, click on System Scan.
4 Click Commit.
5 A warning box appears.
If you want to continue click Yes. The
configuration completes and the Health and
Status Monitor page appears.
If you wish to start over, click No.The Setup
Wizard page appears.
Custom initial setup
If the application setups do not suit your needs,
you may use Custom Setup to configure the
FastStream SC 5300.
1 If you have chosen the Custom Setup button,
the RAID Setup Wizard page appears.
2 Click on Next.
3 Select a RAID level. Refer to Designing RAID
groups on page iii of the Appendix
4 Type a name for your RAID group in the box
provided on the page under the Step 2
heading.
5 Click Next.
6 Note the setup you have chosen. If you want to
change the Interleave level, click on the drop
down box.
CAUTIONCAUTION
Changing the default interleave size may
degrade performance.
7 Click on the System Scan button to discover
the drives available for RAID configuration.
8 When the scanned drives box is populated,
click on the boxes representing the drives for
the RAID group named in Step 4
.
9 Click Next.
10 Partition the RAID group as defined in Partition
RAID groups on page 11. Partitioning allows
you to divide a single RAID group into multiple
independent partitions. If you don't want to use
Partitions, click on the All Unallocated button.
11 Click Create. The partitioning you have chosen
appears.
12 Click Next.
13 Step 6 asks you to verify the setup. If the setup
is correct, click on Commit.
14 A warning box appears.
If you want to continue click Yes. The
configuration completes and the RAID Setup
page appears allowing you to continue making
RAID groups or to end the session.
If you do not want the setup, click No and the
RAID Setup Wizard page appears.