Instruction manual

5
ATTO Technology Inc. FastStream SC 5300 Installation and Operation Manual
2.0 Installation
If you have not already completed the instructions on the Quick Start page packed with your FastStream
SC 5300, use the following instructions to install the FastStream SC 5300.
Unpack the packing box; verify contents
• The FastStream. Note the serial number of your
FastStream unit: ________________________
• Power cord
• “L” brackets for mounting in a 19” rack
• Ethernet cable
• RS 232 cable
• CD which includes the Firmware, Installation
and Operation Manual, QuickNAV™ IP
discovery program and system drivers
Install the FastStream
1 Place the FastStream SC 5300 on a stable flat
surface or install it into a standard rack.
If installing into a rack, see Exhibit 2.0-1.
a. Attach “L” brackets so that the front side
with the LEDs face front and the connector
side is at the back.
b. Install the FastStream horizontally within
the rack so it does not reduce the air flow
within the rack.
2 Connect and power up Fibre Channel devices
from your SAN to the FastStream using SFPs
and multimode fiber optic cables for the Fibre
Channel ports. Keep cable lengths as short as
possible to ensure the highest signal quality
and performance. See Exhibit 2.0-2 on page 6
and refer to Cabling
on page i of the Appendix.
3 Connect and power up SCSI target
devices.See Exhibit 2.0-2 on page 6 and refer
to Cabling
on page i of the Appendix.
4 Connect the Ethernet port to your network.
5 Connect the AC power cord from the
FastStream to the proper AC source outlet.
CAUTIONCAUTION
The power source must be connected to a
protective earth ground and comply with
local electrical codes. Improper grounding
may result in an electrical shock or damage
to the unit.
If you are using a rack:
a. Properly ground the FastStream to the rack
equipment. The earth ground connection
must be maintained.
b. The power requirements plus the power
draw of the other equipment in the rack
must not overload the supply circuit and/or
wiring of the rack.
6 Turn on power to the FastStream using the
power switch.
7 Wait up to two minutes for the FastStream
Ready LED to light indicating the FastStream
has completed its power-on self test sequence.
Discover the IP address
Note
The FastStream SC 5300 is initially configured
with DHCP enabled. It is best if you have
access to a DHCP server.
1 Work from the computer attached to the
FastStream SC 5300 Ethernet port on the same
broadcast domain. From the CD supplied with
your FastStream, run the QuickNav Utility
QuickNAV-windows.exe for Windows or
QuickNAV-Mac for Mac OS X.
2 Locate the FastStream with the serial number
recorded earlier.
3 Highlight the serial number.
4 Click Next.
If a DHCP server is available on your network,
an address is assigned automatically by the
server. Note the assigned address:
_____________________________________
If you do not have a DHCP server, get an IP
address and subnet mask from your network
administrator, type it into the area provided, and
click on Next.
5 Click on Launch Browser
Your browser points to the ATTO ExpressNAV
splash screen. If you use Internet Explorer as a
browser, continue on to Internet Explorer setup
below. If not, continue on to Begin initial
configuration .