Instruction manual

3
ATTO Technology Inc. FastStream SC 5300 Installation and Operation Manual
1.1 Physical attributes
The ATTO FastStream SC 5300 is a Fibre Channel to SCSI storage appliance which can be seamlessly integrated
into an existing storage environment.
The ATTO FastStream SC 5300 is available in an
industry-standard 1U form factor for easy integration
into racks. It supports next-generation media and, as a
result, is equipped to handle the throughputs needed by
advanced disk technologies.
Dimensions
Width: 17 inches
Length: 8.94 inches
Height: 1.7 inches (1U)
Weight: approximately 8 pounds
Cooling and airflow
Operating Temperature: 0°-40° C external
Humidity: 10-90% non-condensing
Airflow: air enters through slots on the right of the
rear panel and exits through slots on the left of the rear
panel.
CAUTIONCAUTION
Do not block the enclosure’s vents. The
FastStream SC 5300 does not allow data
transfer if overheating occurs.
Power
The power supply circuit is permanently mounted
within the enclosure and is not hot-swappable. It has
one standard IEC320 power receptacle and switch.
CAUTIONCAUTION
The power source must be connected to a
protective earth ground and comply with
local electrical codes. Improper grounding
may result in an electrical shock or damage
to the unit.
Input voltage:
10/230V AC, with operating input
range of 90-132V AC or 175-264V AC, 47-63Hz,
single phase. The AC input range selection is
automatic with no manual or jumper switchover
required.
Power draw: 2 amps at 110V, 1.6 amps @ 90V
Fibre Channel port
Two independent 4-Gigabit Fibre Channel ports
connect the FastStream SC 5300 to either a Fabric or
Arbitrated Loop using Small Formfactor Pluggable
(SFP) interfaces. Keep cable lengths as short as
possible to ensure the highest signal quality and
performance. For details, refer to
Cabling on page i of
the Appendix.
SCSI ports
The two SCSI ports connect storage devices into the
Fibre Channel Storage Area Network (SAN). Each
port is totally independent from the other.
The ports are Ultra 320 SCSI busses with VHDCI
connector, downward compatible with all forms of
Single-ended Differential SCSI and all previous SCSI
protocols.
Ethernet port
The 10/100 base T Ethernet port is accessible from the
RJ45 connector and supports local diagnostics.
Serial port
The RS-232 serial port provides support
for remote monitoring and management
using a DB9 connector. The baud rate is
programmable and preset at the factory
to 115200 bps.
Reset/restore factory default switch
To reset the FastStream, briefly insert a tool in the hole
in the back panel.
To restore factory defaults, insert the tool in the hole in
the back panel for more than four seconds until the
green Ready LED blinks.
1
9
8
7
6
5
4
3
2
RX
TX
GND