Installation manual

66
Exhibit 1.5-4 The “Delete Confirmation” window
• Click Yes in the Delete Confirmation window
to delete the port. If the virtual port is deleted
successfully, it will be removed from the
Virtual Ports list and the Status window will
read: “Deleted virtual port <Port Name>”,
where <Port Name> is the World-Wide-Port-
Name of the deleted port.
If the delete operation fails, the ConfigTool will display
the NPIV Error window, illustrated in
Exhibit 1.5-3 .
Refer to the NPIV Troubleshooting section for a
complete list of the errors that can occur during port
deletion and recommendations for correcting common
problems.
NPIV Troubleshooting
The NPIV Tab is not visible in the
Configuration Options window for the
selected channel.
The NPIV tab will not appear in the Configuration
Options window for any of the following reasons:
• The selected channel is not an 8Gb or 16Gb
Celerity adapter channel.
• The remote host associated with the
selected channel is not running Windows.
• The remote host associated with the
selected channel is running an older version
of the ConfigTool. NPIV support is available
only in versions 4.09 and later.
The NPIV Tab is available, but only
contains the message: “This version of
the driver does not support NPIV”.
The version of the Celerity driver installed on the
remote host associated with the selected channel
does not support NPIV. Updated drivers are available
on the ATTO web page (
www.attotech.com ).
The NPIV Tab is available, but the reported
NPIV Status is not OK.
If the NPIV status of the selected channel is not OK,
look up the reported status in the following table and
perform the steps called out in the Corrective Action
column. Note that some actions may require a system
restart to take effect.