Installation manual

48
Exhibit 1.4.1--28 Enable Rebuild Recovery
The RAID Group status will change from Offline to
Degraded . The Rebuild status will change from
Rebuilding (Faulted) to Recovery Rebuilding (n%) ,
where n% is the completion percentage of the rebuild
process.
At the end of the Rebuild Recovery, barring major
problems, the RAID Group will be put back online.
However, at the location corresponding to the Media
Error, the data may be invalid! Anytime a RAID Group
goes OFFLINE, data integrity
has been
compromised.
It is imperative that data consistency
checks and file system repair tools are used to validate
the data before trying to use it.
Exhibit 1.4.1--29 Recover Rebuild; Rebuild Completes;
RAID Group goes ONLINE
Note
If the rebuild cannot continue to the end
because of unrecoverable errors on multiple
drives, use the Extreme recovery mode,
described below, to try to recover data.
1 2 3
4A