Installation manual

Contents
1.0 ATTO ConfigTool ...........................................................................................1
Pre-Installation
Installation
Using the ATTO ConfigTool
Navigating the ConfigTool
Driver update
System Reboot
1.1 Celerity and ThunderLink FC NVRAM Settings ................................10
1.2 FastFrame NVRAM Settings ...............................................................12
1.3 ExpressPCI NVRAM Settings .............................................................13
1.4 ExpressSAS, ThunderLink SH and ThunderStream SC
NVRAM Settings ..................................................................................15
1.4.1 RAID Configuration ..........................................................................17
Preliminary Steps
Setting up DVRAID
Customizing a RAID setup
Creating a Hot Spare Pool
Modifying RAID Groups
Replacing a faulted drive
Setup RAID Notification
Using SCSI Enclosure Services (SES)
Identifying Drives
Selecting All Drives in the Same Enclosure
Monitoring Health
Monitoring S.M.A.R.T. Data
Enabling or Disabling S.M.A.R.T. Monitoring
Checking S.M.A.R.T. Status
Filtering S.M.A.R.T. Attributes
S.M.A.R.T. Notifications
Test Drive Performance
RAID Media Scan Feature
Starting a Media Scan
Media Scan Status
Viewing the Scan Report
Pausing or Resuming Media Scan
Scheduling Media Scan
Viewing Scheduled Tasks
Automatic Cancellation of Media Scan
Data Recovery for OFFLINE RAID Groups
Definitions
Failure Scenario Table
Drive Replacement on a Failure Condition
Recovering from Failed Drives
File System Repair Tools
Command Line Interface
CacheAssure™