Installation manual

iii ATTO Technology Inc. ATTO Utilities Installation and Operation Manual
ERROR Invalid number of Partitions specified
ERROR Invalid Span Depth specified
ERROR Cannot perform operation on mapped Partition
ERROR Cannot perform operation. RAID Group has mapped Partitions
ERROR Cannot perform operation. RAID Group has Outstanding Commands
ERROR Block Device at specified index no longer available
ERROR Insufficient RAID Group members for RAID type
ERROR Incorrect number of RAID Group members for QuickVideo configuration
ERROR Invalid Virtual Drive ID
ERROR Specified capacity is invalid
ERROR Too many Indices specified.
ERROR Only one add storage operation is permitted at any given time.
ERROR No free block devices
ERROR Cannot benchmark a drive that is being initialized
ERROR Specified drive is not being monitored
CLI summary
The following chart summarizes the Command Line Interface commands, their defaults, and an example of how
to enter the commands. Commands which have no default values have a blank entry in that column of the table.
CAUTIONCAUTION
Do not use CLI unless you are directed to by an ATTO technician.
Changing parameters may cause loss of data and/or disruption to performance and reliability of
the ExpressSAS adapter.
Command Default Example
AutoMap automap
AutoMapOnBoot disabled set automaponboot enabled
AutoResume
rebuild = enabled
erase = disabled
initialize = enabled
set autoresume erase enabled raidgroup1
BlockDevClean blockdevclean 30
BlockDevIdentify blockdevidentify 30
BlockDevIDStop blockdevidstop
BlockDevInfo blockdevinfo
BlockDevScan blockdevscan
BuzzerOnError (6Gb RAID Adapter
w/CacheAssure)
set buzzeronerror enabled
BuzzerTest (6Gb RAID Adapter
w/CacheAssure)
buzzertest on 5
CACacheStatus (6Gb RAID Adapter
w/CacheAssure)
get cacachestatus
CACleanCache (6Gb RAID Adapter
w/CacheAssure)
cacleancache
CAPowerStatus (6Gb RAID Adapter
w/CacheAssure)
get capowerstatus
CAProtectionMode (6Gb RAID
Adapter w/CacheAssure)
Hi (High)
Protection
set caprotectionmode hiperformance