Installation manual
ii
Exhibit A-1 Symbols, typefaces and abbreviations used to indicate functions and elements of the command line
interface used in this manual.
CLI error messages
The following error messages may be returned by the
Command line Interface
ERROR Invalid Command. Type 'Help' for command list.
ERROR Command Not Processed
ERROR Wrong/Missing Parameters
ERROR Invalid Hot Spare Serial Number
ERROR Invalid RAID GroupName
ERROR Invalid RAID Group State
ERROR Insufficient number of RAID Group members
ERROR RAID Group does not exist
ERROR No RAID Groups found
ERROR Invalid RAID Type
ERROR RAID Group is already unmapped
ERROR Invalid Block Device Index
ERROR Invalid RAID MemberIndex
ERROR Invalid RAID Member State
ERROR Missing RAID Member
ERROR Invalid RAID Member Capacity
ERROR Invalid Partition Index
ERROR Maximum number of RAID Groups exceeded
ERROR Maximum number of Partitions exceeded
ERROR Invalid number of Partitions
ERROR Maximum number of RAID Members exceeded
ERROR Maximum stripe width
Symbol Indicates
[ ] Required entry
< > Optional entry
| Pick one of
n-n A range (6 – 9 = 6, 7, 8, 9)
BlockDevID Index designation of a block device not assigned to any other RAID group;
the index of a block device provided by the BlockDevScan (Immediate,
Disabled on Error) command.
0<=n<=63
GroupName The name of the RAID group to which the block device is assigned, or
blank if the block device is available
MemberIndex Index designation of a RAID group member as found in the RMStatus
(Immediate) command
PartIndex Index designation of a partition as found in the PartitionDisplay
(Immediate) command
SASIndex Index designation of SAS drives as found in SASTargets (Immediate,
Disabled on Error)
TID Target ID: 0<=n<=255