Setup guide

Version 3.3 Upgrade Notes
28
17. Click the Look In pop-up menu, and select CD-ROM.
18. On the MediaNetwork CD-ROM, navigate to:
\Drivers_Firmware\HostBusAdapters\Emulex\Drivers\Win2K
19. Make sure that the file name reads OEMSETUP or OEMSETUP.INF.
20. Click Open. The Locate Files dialog box closes.
21. Click OK in the Install From Disk dialog box. The Select a Device
Driver screen shows Emulex LP6000/7000/8000 in the Upgrade
Device Driver Wizard.
22. Click Next. An Update Driver Warning appears.
23. Click Yes. The Start Device Driver Installation screen appears.
24. Click Next. A Digital Signature Not Found dialog box opens.
25. Click Yes. The Hardware Installation screen appears.
26. Click Next. It takes several minutes to install the driver. This time
varies based on the Avid workstation. When finished, the Completing
the Upgrade Device Driver Wizard shows a finished installing the
software message.
n
You might see a Digital Signature Not Found dialog box for each drive in
the drive set. Click No and Finish as each dialog box opens.
27. Click Finish.
28. Click Close in the Fibre Channel Controller Properties dialog box.
29. Reboot the client.
Installing the Emulex SimulateDevice Driver
If your Windows Fibre Channel client has an Emulex Fibre Channel
adapter board and you are upgrading from MediaNet Release 2.2.1 or
earlier, you must upgrade the Emulex SimulateDevice before upgrading to
MediaNetwork v3.3.
0578801A_UP.fm Page 28 Tuesday, May 6, 2003 4:47 PM