Setup guide

Upgrading Windows 2000 Clients
27
Upgrading the Emulex Fibre Channel Driver
If your Windows Fibre Channel client has an Emulex Fibre Channel
adapter board and you are upgrading from MediaNet Release 3.0 or earlier,
you must upgrade the Emulex driver before upgrading to MediaNetwork
v3.3.
To install the Emulex Fibre Channel driver on a Windows 2000
system:
1. Insert the MediaNetwork CD-ROM into the Windows 2000 system
CD-ROM drive. The MediaNetwork Installation window opens after
approximately 1 minute.
2. Click the Exit button to close the installation window.
3. Right-click My Computer on the desktop, and select Manage. The
Computer Management window opens.
4. In the left portion of the window, click Device Manager. A list of
devices appears in the right portion of the window.
5. Expand SCSI and RAID Controllers. A list of available controllers
appears.
6. Right-click Emulex Adapter.
7. Click the pop-up menu and select Properties. The Fibre Channel
Controller Properties dialog box opens.
8. Click the Driver tab.
9. Click the Update Driver button. The Upgrade Device Driver Wizard
starts.
10. Click Next. The Install Hardware Device Drivers screen appears.
11. Click the “Display list of known drivers” button.
12. Click Next. The Select a Device Driver screen appears.
13. Click the Have Disk button. The Install from Disk dialog box opens.
14. Click Browse.
15. Click the “Copy manufacturer’s” files pop-up menu, and select the
CD-ROM drive.
16. Click Browse. The Locate Files dialog box opens.
0578801A_UP.fm Page 27 Tuesday, May 6, 2003 4:47 PM