Product specifications

Upgrade Instructions
22
5. Carefully center the cables of the new Meridien III-U 3D effects
daughter board
over the cable connectors on the digital media board
(see Figure 5) and squeeze them until they are properly seated.
6. Check to make sure the connector between the boards is still properly
connected (it sometimes comes loose).
Connecting the New Meridien 3D Effects Board
Once you have the new Meridien III-U 3D effects daughter board firmly
attached to the digital media board, you need to connect the
Meridien III
-U board set to the new Z6 board. It is easier to place the new
Z6 board and the Meridien III-U board set into the PCI slots separately,
and then attach the over-the-top connector.
To connect the two boards:
1. Carefully place the new Z6 board into the proper slot of the PCI as
shown in Table 1, Table 2, or Table 3 depending on the system you
have.
2. Carefully place the Meridien III-U board set into the proper slot of the
PCI as shown in Table 1, Table 2, or Table 3 depending on the system
you have.
3. Screw the boards to the connector strip at the rear of the system.
4. Carefully position the hard over-the-top connector over the two board
sets, and gently, but firmly, press the connector until it is properly
seated.
n
You might have to jiggle the board sets slightly to get the over-the-top connector to
line up properly.
5. Connect the external cable between the Meridien III-U board set and
the Meridien I/O box. Connect the cable to the “M” connector of the
Meridien III-U board set.
6. Connect the cable from the display controller board to the
Meridien III-U board set.