Product specifications

Installing the Avid Boards into the System
19
Figure 3 Removing the Over-the-Top Connector
n
Figure 3 shows the over-the-top connector connected to a different 3D
effects board. Removal is the same.
t The second method is to gently rock the board sets up and down until
the over-the-top connector becomes loose, and then remove it.
n
You should now remove the old 3D effects board (Genie) and place it on a
static-free location.
Removing the Old Meridien 3D Effects Daughter Board
You now need to remove the old Meridien 3D effects daughter board
(Copperhead Lite or Rattlesnake) from the Meridien II digital media
board, and replace it with the new Meridien III-U 3D effects daughter
board (Copperhead). You will need a plastic pen or some other
nonconducting instrument with a blunt end.
Incorrect
Correct
Do not pry from end.
Grasp here on both sides.
Over-the-top connector