Technical information

8
Using ExpressRAID
menu and select Enable Auto Detection . (If
Enable Auto Detection has a check mark ( 9 ) in
front of it, then it is enabled).
If you would like to ignore Auto Detection , select
Nothing , proceed to Main Window and click OK .
Returning to the
Main Window allows other
options to be selected.
If you want to ignore Update ATTO Drivers ,
select
Nothing , proceed to Main Window and click
No for Update ATTO Drivers . Returning to the
Main Window allows you to select other options.
Adjust other parameters
To access these options, go to the device window
and double click on a device or drive. These
options are stored on disk and apply to the
ExpressRAID driver only.
Tag Command Queuing
Choices: enable, disable
Default: disabled
A feature of SCSI-2 and SCSI-3 protocols, allows
SCSI commands to be executed out of order by a
supporting SCSI device to increase speed for large
amounts of small I/Os.
Non-ATTO LUNs Enabled
Choices: enable, disable
Default: disabled
Allows non-zero LUNs attached to third party
host adapters to mount on your desktop at boot
time. If you create an ATTO volume (RAID or
non-RAID) on LUN(s), then the ATTO driver will
control those LUN(s).
This applies to both zero and non-zero LUNs. At
boot-time, the ATTO driver will not scan for non-
zero LUNs unless the device is on an ATTO host
adapter. If the disk at LUN 0 has the Non-ATTO
LUNs Enabled,
then the ATTO driver will
continue to scan LUNs at this ID.
Spindown before shutdown/restart
Choices: enable, disable
Default: disabled
Spins a drive down so it can be removed during
shutdown.
Canister (Pseudo-Removable) RAID 0 only
Choices: enable, disable
Default: disabled
Treats hard drives like removable media to allow
you to swap drives. The drive spins down when
dragged to the trash. The drive will automatically
remount when reinserted.