Diamond Storage Array Installation, Operations, Maintenance Manual

6.4 RAID Level 5 .........................................................................59
Configuring a fully-populated array
To set up one RAID Level 5 group with one Hot Spare sled
To set up two RAID Level 5 groups with two Hot Spare sleds
Configuring a partially-populated array
To set up one RAID Level 5 group with one Hot Spare sled
Removing RAID groups
6.5 RAID Level 10 .......................................................................63
To set up RAID Level 10 groups
To remove RAID groups
Hot Spare sleds
To set up RAID Level 10 with Hot Spare sleds
6.6 Rebuilding RAID Configurations ........................................65
To reset LUN status
To synchronize mirrored drives automatically
Rebuild priority
To synchronize mirrored drives manually
6.7 RAID Interleave Parameters ................................................67
To change the RAID Interleave parameter
7.0 Hardware Maintenance ...................................................................69
To remove a management card
To remove a disk drive sled (Exhibit 7-2)
To remove a Host Interface Card
To remove the power supply (Exhibit 7-4),
To remove a blower assembly (Exhibit 7-4),
7.1 Hot Swap Operating Instructions .......................................71
Disk drives
Power supplies
Blower assemblies
To replace a blower assembly
7.2 Optional Hot Spare Sled ......................................................73
To set up RAID Level 1 with Hot Spare sleds
To set up RAID Level 10 with Hot Spare sleds
To set up one RAID Level 5 group with one Hot Spare sled
To set up two RAID Level 5 groups with Hot Spare sleds
8.0 Copying Drives ................................................................................75
Procedure
9.0 Updating Firmware .........................................................................77
Updating firmware using the RS-232 serial port
To update firmware
Updating firmware using the optional Ethernet card