Specifications

Managed Data Path Model 18
4.2 Ethernet and Telnet configuration commands
Configure the ATTO FibreCenter 3400R/D using a telnet session over the Ethernet port. The commands
in this section configure or provide information about the Ethernet port and the Telnet session.
Default Router
Sets a new default router address for the telnet server. Set the default router within the subnet as defined by the subnet mask and IP Address.
Limit: 0-255
Default: 0.0.0.0
Action:
set Default Router[n.n.n.n]
Information:
get Default Router
Commit Zone
or power cycle
Echo
Sets the telnet command echo mode.
Limits: [on|off]
Action:
set Echo [on|off]
Information:
get Echo
Commit Zone
or power cycle
Factory Defaults
The telnet parameters are set to their factory default values.
Action:
set Factory Defaults
Information: none
Reset
or power cycle
Idle Timeout
Sets time period in minutes after which, if there is no action on the telnet port, the telnet session is shut down.
Default: 60 minutes
Action:
set Idle Timeout [n]
Information:
get Idle Timeout
Commit Zone
or power cycle
IP Address
Sets a new IP address which will be used after next reset.
Limit: 0-255 Default: 192.168.1.1
Action:
set IP address [n.n.n.n]
Information:
get IP Address
power cycle
Security Traps
Sets the telnet security level
Default: 3
Action:
set Security Traps [n]
Information:
get Security Traps
Commit Zone
or power cycle
Subnet Mask
Sets a new subnet mask which will be used after next reset.
Limit: 0-255 Default: 255.255.255.0
Action:
set Subnet Mask [n.n.n.n]
Information:
get Subnet Mask
power cycle