Specifications

Managed Data Path Model 6
hub is 192.168.1.1. You can use a crossover
Ethernet cable to direct connect a PC to the
FibreCenter 3400D or a standard Ethernet
cable to attach to a network device.
7 Change the IP address of the host computer
to 192.168.1.X (where X does not equal 1).
8 Launch a Hyperterminal session.
9 From the menu bar at the top, select
File -
New Connection
10 Enter a name for the connection.
11 Select
TCP/IP
as the connection method.
12 Enter the IP address of the FibreCenter
(default is 192.168.1.1)
13 Enter
zonedhub
(the factory default login)
when prompted for the login.
14 Enter
zonedhub
(the factory default
password) when prompted for the
password. (Make sure local
echo
is off
before entering a secure password).
15 A
>
prompt will be displayed if the user
name and password were entered
successfully. You should now be connected.
Type
help
for a list of commands. Enter the
CLI commands required to set up your
system if different from previously set
configurations. (See Chapter 3.4)