Specifications

5
ATTO FibreCenter 3400
Ins
tallation and Operation Manual
3 ATTO FibreCenter installation options
The ATTO FibreCenter 3400R/D provides a 2-gigabit Fibre Channel rackmount or desktop hub with
eight Fibre Channel ports configured via an Ethernet port.
The ATTO FibreCenter 3400R/D hub integrates
industry-leading performance and Storage Area
Network capabilities into mid-range applications.
Available for integration into the ATTO Fibre
Channel Rack System as a rackmount module or
as a stand alone desktop module which also can be
mounted in a rack, the ATTO FibreCenter
3400R/D hub provides dependable performance
for high availability systems.
Quick start instructions
The ATTO FibreCenter 3400R/D offers a variety
of ways to connect into a SAN. The following is a
quick start description.
To integrate the FibreCenter 3400R into the
ATTO Fibre Channel Rack System
1 Slide the hub module horizontally into the
rack enclosure until you feel it make contact
with the backplane connector.
2 Secure the hub module by tightening the
two thumbscrews (hand tight).
3 Apply power to the rack enclosure. The
FibreCenter 3400R will be active
approximately 40 seconds after power is
applied.
4 Connect to the management port via a
standard RJ45 Ethernet cable.
5 Connect Fibre Channel devices to the ATTO
FibreCenter using SFPs and standard
cables manufactured for Fibre Channel use.
6 Connect a host computer to the
FibreCenter. The default IP address of the
hub is 192.168.1.1. You can use a crossover
Ethernet cable to direct connect a PC to the
FibreCenter 3400R or a standard Ethernet
cable to attach to a network device.
7 Change the IP address of the host computer
to 192.168.1.X (where X does not equal 1).
8 Launch a Hyperterminal session.
9 From the menu bar at the top, select
File -
New Connection
10 Enter a name for the connection.
11 Select
TCP/IP
as the connection method.
12 Enter the IP address of the FibreCenter
(default is 192.168.1.1)
13 Enter
zonedhub
(the factory default login)
when prompted for the login.
14 Enter
zonedhub
(the factory default
password) when prompted for the
password. (Make sure local
echo
is off
before entering a secure password).
15 A
>
prompt will be displayed if the user
name and password were entered
successfully. You should now be connected.
Type
help
for a list of commands. Enter the
CLI commands required to set up your
system if different from previously set
configurations. (See Chapter 3.4)
To set up the FibreCenter 3400D
1 Set the FibreCenter 3400D where you want
it, either on a flat surface or mounted inside
a rack using brackets and the mounting
holes on the hub’s case.
2 Insert the power cable into the power
connector.
3 Apply power. The FibreCenter 3400D will be
active approximately 40 seconds after
power is applied.
4 Connect to the management port via a
standard RJ45 Ethernet cable.
5 Connect Fibre Channel devices to the ATTO
FibreCenter using SFPs and standard
cables manufactured for Fibre Channel use.
6 Connect a host computer to the
FibreCenter. The default IP address of the