Manualshelf

Setup guide

ManualsBrandsATTO Technology ManualsSwitch3400
51525354555657585960
Connecting the USB-to-MIDI Converter
55
Connecting the USB-to-MIDI Converter
If you are using a JL Cooper controller in an HP Workstation you must install a USB-to-
MIDI converter (see the following figure). The MIDISPORT 2x2 by M-AUDIO has been
tested with the Avid DS Nitris system. You need a USB cable that connects to a USB port on
the Avid DS Nitris system. Only connect the USB-to-MIDI converter if you are going to
use it.
n
Before you use the USB-to-MIDI converter, you must install the latest revision of the driver.
Go to www.midiman.net and install the latest revision for the MIDISPORT 2x2.
USB-to-MIDI Converter
To connect the USB-to-MIDI converter to a port on the system
1. Locate the MIDI converter USB cable.
2. Connect the device connector of the USB cable to the device connector at the rear of the
USB-to-MIDI converter.
3. Connect the USB connector of the USB cable to a USB port at the rear of the PC.
4. Press In the USB/MIDI Thru button, at the front of the USB-to-MIDI converter, to allow
the device to act as a USB-to-MIDI converter.
Button (In position)
Rear
Front
Cable to USB
port on system