Setup guide

Connecting the Avid Nitris DNA
47
Connecting the Avid Nitris DNA
To connect the Avid Nitris DNA to the workstation (see the following figure):
1. Make sure that the power switch on the Nitris DNA is Off.
2. Attach the power cord to the power connector at the back of the Nitris DNA and plug it
into a power outlet.
3. Plug one end of the digital interlink cable into the SYSTEM connector at the back of the
Nitris DNA.
4. Plug the other end of the digital interlink cable into the digital interlink connector on the
Avid Nitris Base board.
5. Make sure both ends of the cable are secure.
n
Power-on the Avid Nitris DNA after you have turned on your computer.
Connecting the Avid Nitris DNA
In
1/A
Out
1/A
Out
2/B
In
2/B
Base
Codec
12345678
HD SDI IN HD SDI OUT
ANALOG AUDIO IN
ANALOG IN
ANALOG OUT
SDI DAE LTC
SYSTEM
ANALOG AUDIO OUT
HD MONITOR OUT
MONITOR OUT
DIGITAL AUDIO
YPB
S/P DIF
PR
Y
SD SYNC PB PR Y
PB PR
HD TRILEVEL
SYNC
OUT 1
MIC 1 MIC 2
OUT 2
GAIN
1234567
8
GAIN
IN
IN
IN OUT
CV 1
CV 2
OUT
OUT 1
OUT 2 OUT
2
1
IN
IN/OUT
CV S-VIDEO
S-VIDEO
NITRIS HD
HD COMPONENT OUT
OPTICAL
AES/EBU
Digital interlink cable
Avid Nitris DNA
System connector
Avid Nitris DNA
base board connector
Power
connector