Instruction manual

xiii
ATTO Technology Inc. FibreBridge Installation and Operation Manual
CAUTIONCAUTION
If you set this value too low, failures may
occur during normal operation.
Default: 250
set SCSIPortSelTimeout [sb] [ 250 | 128 | 64 | 32 | 16 | 8
| 4 | 2 | 1 ]
get SCSIPortSelTimeout [sb]
SCSIPortSyncTransfer
Specifies whether synchronous SCSI transfers should be
negotiated with devices on the specified SCSI port.
Default: enabled
set SCSIPortSyncTransfer [sb ] [enabled | disabled]
Requires a SaveConfiguration command
get SCSIPortSyncTransfer [sb]
SCSIPortTermination
Configures/reports the SCSI internal termination of the
SCSI port identified on the FibreBridge.Enabling
termination allows the FibreBridge to act as a terminator
at the end of a SCSI chain.
Default: enabled
set SCSIPortTermination [sb] [enabled | disabled]
Requires a SaveConfiguration command
get SCSIPortTermination [sb]
SCSIPortWideTransfer
Specifies whether wide SCSI transfers should be
negotiated. Enabled allows wide transfer negotiation
Default: enabled
set SCSIPortWideTransfer [sb] [enabled | disabled ]
Requires a SaveConfiguration command
get SCSIPortWideTransfer
SCSITargetLUNs
Controls the maximum number of SCSI LUNs per target
the FibreBridge queries during a SCSI bus scan.
Default: 8
set SCSITargetLUNs [sb] {8 | 64]
Requires a SaveConfiguration command
get SCSITargetLUNs [sb]
SCSITargets
Lists the physical devices connected and running on the
specified SCSI port.
SCSITargets [sb]
SerialNumber
Reports the FibreBridge serial number. The serial
number, unique for each FibreBridge, is a 13-character
field. The first seven alphanumeric characters are an
abbreviation of the FibreBridge name while the
remaining six numbers are the individual FibreBridge
board’s number.
get SerialNumber
SerialPortBaudRate
Configures/reports the baud rate for the FibreBridge RS-
232 serial port or header. The number of data bits per
character is fixed at 8 with no parity. Choices are 9600,
19200, 38400, 57600 and 115200
Default: 115200
set SerialPortBaudRate [9600 |19200 |38400 | 57600
|115200]
Requires a SaveConfiguration Restart command
get SerialPortBaudRate
SerialPortEcho
Control/reports the status of the display of keyboard
input. When enabled, all non-control character keyboard
input is output to the display. Local ASCII terminal (or
terminal emulator) echo settings should be set to
disabled while using SerialPortEcho enabled
Default: enabled
set SerialPortEcho [enabled | disabled]
Requires a SaveConfiguration Restart command
get SerialPortEcho
SNMP
Controls whether or not SNMP functions on the
FibreBridge.
SNMP [enabled | disabled]
Default: enabled
SNMPDumpMIB
Displays the contents of the ATTO FibreBridge private
SNMP MIB to the current CLI session. Consult your
network administrator for further assistance with SNMP.
SNMPDumpMIB