Instruction manual

29
ATTO Technology Inc. FibreBridge Installation and Operation Manual
Advanced CLI configuration
Allows you to input any CLI command available
through the FibreBridge.
1 Type in the CLI command in the text box.
2 Click the Submit button: this is equivalent to
typing in the CLI command into a TCP/IP or
serial port CLI session.
A text field beneath the box lists the most recent
commands issued to the FibreBridge through
this page.
If you enter an incorrect parameter, the CLI
help text is displayed, showing the parameters
available.
3 If your entry was correct, type
saveconfiguration
4 Click the Submit button. Your changes are
implemented.
Restart firmware
Implements a firmware restart of the bridge and
makes permanent any changes you have made
since the last firmware restart.
CAUTIONCAUTION
Restarting the firmware may take a few
minutes.
1 Click the Restart button.
A box tells you to wait until the counter gets to
0 and then the browser refreshes.
2 If the browser does not refresh after the counter
gets to 0, click the link to refresh it manually.
Help
Gives help information about the command line
interface commands and troubleshooting tips via
links to pages with help text for each category of
options and one link to the Troubleshooting Tips
and FAQs page on the ATTO website,
www.attotech.com.
Contact information for ATTO technical support
is on the right. Help is always available by
pressing any word shown in red on the screen.