Instruction manual

19
ATTO Technology Inc. FibreBridge Installation and Operation Manual
3.2 Optional changes to system configurations
Default values are appropriate for most configurations, but may be modified for your needs using ATTO
ExpressNAV.
It is best practice to change the default user name
and password to a user name and password
significant to you.
Change current user name, password
1 If you have not already, open an ExpressNAV
session. For instructions, refer to
Open an
ExpressNAV session on page 27.
2 Click
Bridge.
The
Bridge Configuration page is displayed.
The user name that you are currently logged in
with is displayed in the
Username text box.
3 Enter the current
Admin password in the first
line of the boxed area.
4 Enter appropriate information into the
Admin
Username, New Admin Password, and
Confirm New Admin Password text boxes.
Note
The user name is case insensitive and
password is case sensitive.
5 Click Submit.
6 The user name and password for all Telnet,
FTP and ATTO ExpressNAV sessions is
changed.
Enhance performance
SpeedWrite is a method to improve the
performance of WRITE commands to SCSI tape
devices attached to the FibreBridge.
Using the CLI command SpeedWrite , you can
specify the SCSI bus, target and LUN of a mapped
device or specify [all] to set or get the state of all
currently mapped SCSI devices.
SpeedWriteDefault specifies the state of
SpeedWrite for any SCSI devices mapped
manually or via an AutoMap operation. If
enabled, any new SCSI device uses SpeedWrite
performance enhancement by default.
Create a read only password or user name
You may set a read only password or a read only
user name. Refer to Command explanations on
page vi of the Appendix.
1 If you have not already, open an ExpressNAV
session. For instructions, refer to
Open an
ExpressNAV session on page 27.
2 Click
Bridge.
The
Bridge Configuration page is displayed.
The user name that you are currently logged in
with is displayed in the
Username text box.
3 Enter the current
Admin password in the first
line of the boxed area.
4 Enter the desired information into the
Read
Only Username, New Read Only Password
and Confirm New Read Only Password text
boxes.
The user name is case insensitive and password
is case sensitive.
5 Click
Submit.
6 The user name or password for all Telnet, FTP
and ATTO ExpressNAV sessions is changed.