Instruction manual
18
Use ExpressNAV for mapping devices
Use the ExpressNAV interface to map devices
automatically or to customize mapping. You may
modify the mapping as needed to make a device
inaccessible to a host or to replace a non-
functioning mapped unit.
Map devices automatically
1 If not already connected, enter the ExpressNAV
interface.
2 From the ExpressNAV main menu, click on the
Mapping menu item on the left side of the
screen.
3The
Mapping page appears. Wait for the
automatic scan for devices to complete.
4 Click
AutoMap
All the CLI commands necessary to enable
mapping and the command
saveconfiguration norestart are performed.
Map devices manually.
1 From the ExpressNAV main menu, click on the
Mapping menu item on the left side of the
screen.
2The
Mapping page appears. Wait for the
automatic scan for devices to complete.
3 Select the devices from the box on the right
hand side of the screen and drag to the
appropriate LUN on the left.
4 Click
Submit. All the CLI commands necessary
to enable mapping and the command
saveconfiguration norestart are performed
Multiple Node addressing (FB2400 only)
The FibreBridge has a unique Port name for each
Fibre Channel port. By default, each Fibre
Channel port also has a separate unique Node
name. The host computer perceives the
FibreBridge as two separate entities, allowing
mapping of a different set of logical units to each
FC port.
Use the ExpressNAV interface as described
above to map devices to each port.
To change the default setting you must use the
Command Line Interface as described in Use the
serial port or header on page 31.
1 At the Ready prompt, type
set FCMultiNode disabled
Note
Changing the state of the
FCMultiNode
command causes all maps to be deleted.
2Press Enter.
3Type
saveconfiguration
4Press Enter
5 Use the ExpressNAV interface to map devices
to the FibreBridge, or stay in the CLI mode and
use the
Automap CLI command to
automatically map devices or use the
Route
CLI command to define mapping. Refer to
AutoMap
on page vi and
Route
on page xii in
the Appendix for further explanations of the
commands.