Specifications

76
Configuration: optional
Read only password or username for the
FB 2400 only
You may set a read only password or a read only
username. Refer to General use commands
on
page 37.
1 If you have not already, open an ExpressNAV
session. For instructions, refer to
Open an
ExpressNAV session on page 19.
2Click Bridge.
The Bridge Configuration page is displayed.
The username that you are currently logged in
with is displayed in the Username text box.
3 Enter the Admin password in the first line of the
boxed area.
4 Enter the desired information into the Admin
Username, New Admin Password, Confirm
New Admin Password or New Read Only
Password and Confirm New Read Only
Password text boxes.
The username is case insensitive and password
is case sensitive.
5Click Submit.
6 The username or password for all Telnet, FTP
and ATTO ExpressNAV sessions are changed.
Port Failover for FB2400 only
The FibreBridge 2400 may be configured to
reserve a port to take over in case another port
fails.
If you enable Logical Unit Addressing through
the Command Line Interface (refer to Using the
serial port on page 7), you can enable port failover
in which a designated Fibre Channel port is
marked as reserve and becomes active only if
another port fails.
To enable port failover, enter the CLI and type
set FCPortFailover enabled
To restore a bridge that has experienced a failover
to its pre-failover state, type
FCPortRecover
To return an active port back to its pre-failover
state, type
FcPortFailure recover