Specifications

26
Installation: FibreBridge 2400C
Installation instructions
1 Physically place the FibreBridge in your device.
2 Connect a SCSI device to the FibreBridge.
Connect the Fibre Channel port to your
SAN.Connect the Ethernet cable from the Fibre
Bridge to your computer. Refer to Cabling
on
page 3.
3 Connect the power connector.
4 Apply power.
5 Access FibreBridge Services using the
QuickNAV utility. Refer to Configuring the
FibreBridge on page 64.
6 Go to the ExpressNAV Restart page and
restart the FibreBridge.
7 Map your devices.Refer to Mapping
on page
67.
8 Boot the computers on the SAN and check the
configuration. Refer to Additional
configurations on page 17.
Exhibit 1.9-1 FibreBridge 2400C board layout
mounting hole
Ready/
Fault LED
Ethernet
port
Fibre
Channel
ports
SCSI ports
SCSI
activity
LEDs
FC activity
& link LED s
cPCI connector
10-pin
serial
header
mounting hole
mounting hole
power LED