Specifications

20
Installation: FibreBridge 2300E
Installation instructions
1 Mount the FibreBridge in your device.
2 Connect a SCSI device to the FibreBridge.
Connect the Fibre Channel port to your
SAN.Connect the Ethernet cable from the Fibre
Bridge to your computer. Refer to Cabling
on
page 3.
3 Connect the power connector.
4 Apply power.
5 Access FibreBridge Services using the
QuickNAV utility. Refer to Configuring the
FibreBridge on page 64.
6 Go to the ExpressNAV Restart page and
restart the FibreBridge.
7 Map your devices.Refer to Mapping
on page
67.
8 Boot the computers on the SAN and check the
configuration. Refer to Additional
configurations on page 17.
Exhibit 1.6-1 FibreBridge 2300E board layout