Specifications

12
Installation: FibreBridge 1180E
Installation instructions
1 Mount the FibreBridge in your device.
2 Connect a SCSI device to the
FibreBridge. Connect the Fibre
Channel port to your SAN.Connect the
Ethernet cable from the Fibre Bridge to
your computer. Refer to Cabling
on
page 3.
3 Connect the power connector.
4 Apply power.
5 Access FibreBridge Services using the
QuickNAV utility. Refer to Configuring
the FibreBridge on page 64.
6 Go to the ExpressNAV Restart page
and restart the FibreBridge.
7 Map your devices.Refer to Mapping
on
page 67.
8 Boot the computers on the SAN and
check the configuration. Refer to
Additional configurations
on page 17.
mounting hole
mounting hole
mounting hole
mounting hole