Specifications

9
ATTO Technology Inc. FibreBridge Installation and Operation Manual
1.2 ATTO FibreBridge 1180D
The ATTO FibreBridge 1180D is a 1 by 1 (one Fibre Channel port with one SCSI port) Fibre Channel-
to-SCSI bridge for standard applications available in vertical or horizontal interface in a desktop
version. The bridge is designed for high throughput enterprise environments and mission-critical
applications.
The form factor and low cost make the
FibreBridge 1180D an attractive solution to
convert SCSI devices to Fibre Channel and enable
direct connection to Storage Area Networks
(SANs).
• Serverless backup support for SNIA extended
copy command
• Support for manual and auto LUN mapping
• Operating system independent
Dimensions
Length: 10 in. (24.4 cm)
Width: 7.5 in. (19.05 cm)
Height: 2.03 in. (5.1 cm)
Exhibit 1.2-1 FibreBridge 1180D internal schematic
Environmental requirements
Temperature: 0-40° C
Ambient air should not exceed 40°C.
Humidity 10-90% non-condensing
Cooling
A fan draws air at 10 CFM from the back and
sides of the unit and exhausts it out the front and
through the unit’s bottom panel.
Power
Input is 100/240 V~.75/.35A, 50/60Hz. An IEC
320 AC power connector and switch are located
on the back of the unit.
Applying power: Insert supplied AC cord into
unit. Plug cord into outlet.
Fibre Channel port
The Fibre Channel port can connect the
FibreBridge to either a Fabric or Arbitrated Loop.
• 1.0625 gigahertz (80 MB/sec.)
• Class 2 and Class 3 ANSI Fibre Channel
specifications support
• PLDA, Public Loop Login (NL_port) and Fabric
Direct Connect (N_port) support
• Full Duplex transmission support
• MIA compliant DB-9 or Short Wave fiber optic
SE connector
SCSI port
The SCSI port on the FibreBridge 1180E/D
connects storage devices into the Fibre Channel
Storage Area Network (SAN) using an Ultra 2
(LVD) SCSI bus, downward compatible with all
forms of single-ended SCSI.